Fitting a non GW mini on to a base.
Moderator: TFF Mods
- NightDragon
- Legend
- Posts: 1793
- Joined: Sat May 11, 2002 7:53 am
- Location: Curtea des Arges
Fitting a non GW mini on to a base.
How do you guarantee it stays on? Will glue do or is there a better way?
Reason: ''
NUFFLE SUCKS! NUFF SAID!
Heretic
Nuffle Blasphemer's Association
[img]http://www.hpphoto.com/servlet/LinkPhoto?GUID=4dd13d90-202c-2355-3cbb-46081754461c&size=[/img]
Heretic
Nuffle Blasphemer's Association
[img]http://www.hpphoto.com/servlet/LinkPhoto?GUID=4dd13d90-202c-2355-3cbb-46081754461c&size=[/img]
- MistWraith
- Emerging Star
- Posts: 501
- Joined: Sun Nov 03, 2002 11:59 pm
- Location: Springfield, MO
It depends on the model. For most models, Super Glue will hold them just fine. A few models may require pinning, or the use of a silicon based glue.
For example, most reaper models can just be glued don to a plastic base. Confrontation models tend to be a lot more top heavy and often will require me to pin them to the base as well.
For example, most reaper models can just be glued don to a plastic base. Confrontation models tend to be a lot more top heavy and often will require me to pin them to the base as well.
Reason: ''
Blood Bowl is WFB Football, not Football with a bit of generic fantasy garbage thrown in!
- NightDragon
- Legend
- Posts: 1793
- Joined: Sat May 11, 2002 7:53 am
- Location: Curtea des Arges
This is a WestWind model of a zombie. I had it glued down and then started modelling a helmet on and he came off. So clearly I exerted too much pressure, but since this figure needs to be sent to Torg for the NBA team I was wondering whether it would break in transit.
Reason: ''
NUFFLE SUCKS! NUFF SAID!
Heretic
Nuffle Blasphemer's Association
[img]http://www.hpphoto.com/servlet/LinkPhoto?GUID=4dd13d90-202c-2355-3cbb-46081754461c&size=[/img]
Heretic
Nuffle Blasphemer's Association
[img]http://www.hpphoto.com/servlet/LinkPhoto?GUID=4dd13d90-202c-2355-3cbb-46081754461c&size=[/img]